Ir arriba
Información del artículo en conferencia

Improvement of the voltage ride through capability of synchronous generators by excitation control

L. Rouco, C. Ginet, K. Chan, K. Major, O. Malcher, L. Díez Maroto, R. Cherkaoui

43 CIGRE Session - CIGRE 2010, París (Francia). 22-27 agosto 2010


Resumen:
Ten years ago, wind generators used to disconnect from the grid in case of a voltage dip. Undervoltage protection systems used to trip wind generators not only to protect both electric machines and power electronic converters but also to prevent their islanded operation. In the mean-time, the massive development of wind power generation has required the increase of the voltage ride through capability of wind generators to prevent that a fault in the network could cause the collapse of the system. The requirement of voltage ride through capability of wind generators has been incorporated into many grid codes. The main requirement has been established as a time-voltage curve that must be sustained by wind generators. Moreover, the voltage ride through capability requirement has been extended to synchronous generators in a number of grid codes. Grid codes have added new requirements with respect to what IEC and IEEE standards had already established. Grid codes require that synchronous generators should remain connected to the grid in case of transient variations of voltage at the generator step-up transformer HV terminals defined by a time-voltage curve. This paper has reviewed the voltage ride through capability required by a number of grid codes. The comprehensive review has shown that grid code requirements are not uniform. The paper has also studied the sensitivity of synchronous generator response to the English grid code requirements with respect to a number of parameters such as the step-up transformer reactance, the turbine-generator rotor inertia, the synchronous machine short circuit ratio and excitation ceiling factor. The study has been conducted on a generator taken from the technical literature and which data are provided. The sensitivity study has shown that both a lower value of the step-up transformer reactance (0.12 pu) and a higher value of synchronous generator SCR (0.61 pu) would ensure that the Engish grid code requirements in case of solid and non-solid faults are fulfilled. It should be pointed out however that such low transformer reactance or high SCR may not be possible due to other design and economic aspects of the power plant. This paper has outlined a solution for generating units equipped with bus fed static excitation systems. The approach consists in connecting a supplementary dc voltage source in the generator excitation winding when a fault occurs. The paper has shown that such an approach allows compliance with the English grid code requirements.


Palabras clave: Synchronous generators, voltage ride through capability, grid codes, excitation control.


Fecha de publicación: 2010-08-22.



Cita:
L. Rouco, C. Ginet, K. Chan, K. Major, O. Malcher, L. Díez Maroto, R. Cherkaoui, Improvement of the voltage ride through capability of synchronous generators by excitation control, 43 CIGRE Session - CIGRE 2010, París (Francia). 22-27 agosto 2010.


    Líneas de investigación:
  • *Estabilidad: Estabilidad de gran perturbación, ajuste de protecciones de deslastre de cargas por frecuencia, control de la excitación, estabilidad de pequeña perturbación, ajuste de estabilizadores del sistema de potencia, identificación de modelos de reguladores

pdf Solicitar el artículo completo a los autores